Previous | Next

How to Install Pinstriping or Reflective Tape on Your Car or Motorcycle

Pinstriping with vinyl tape or reflective pinstriping can be accomplished easily. You can use a dry method for ordinary pinstriping but not with reflective pinstriping or reflective tape. The formulation for reflective tape is different as well as it will often break if you pull it up to retry. With reflective tape or reflective pinstriping, you should use a wet system. See below.

1. Pinstriping is best installed in a stretch as well as pull method. Pick your installation pathway for the pin striping or reflective tape first, then mark this path. If it will be a straight line, you can tape a guide string to the front as well as rear of the car, pulling slightly on the string to make it straight. This will be your guideline.
2. Attach the first 1" to the front of the car, usually the fender. Pull off the backing as well as slightly stretch the tape as well as extend it to approximately 1/2 the distance on your car. As you slightly tug on the pinstriping, you can make the line perfectly straight. Once you have the position you want, begin to lower the pinstriping to your car body as well as it will attach itself lightly as you lower it to the car body.
3. If using reflective tape, after attaching the first 1", spray the car down with a solution of 6 drops of dishwashing liquid to 1 cup of water. Spray this solution on the car to prevent tacking of the reflective tape, otherwise it will stick as well as break if you should need to pull it up as well as try again.
4. After completing the first half of the car, repeat this same procedure from the ending point to the rear of the car exactly.
5. In all openings such as the hinge as well as latch side of the door, simply take a straight edge as well as cut the pinstripe or reflective tape in the middle, then wrap the excess around the door towards the inside of the vehicle.
6. After installation, lightly tap your finger all along the pinstriping or reflective tape to insure it is sticking, then you can lightly wipe it down with your finger using a light pressure. After several passes along the entire path with your finger, you can push progressively harder on the pinstriping or reflective tape.
7. For a neat job, consider decorative pinstripe ends. These are available in your local automotive store.

• Make sure your vehicle is completely clean. Any tiny spec of dirt or grime will cause a bump under the pinstripe or reflective tape. It is very noticable.
• Overshoot your pinstriping job by 2". Then use a sharp flat edge razor blade to hold against the pinstripe or reflective tape then pull up from the starting point. When the tape pulls up, it will break neatly at the point you are holding the razor blade.
• Consider reflective tape or reflective pinstripe for all of your pinstriping jobs. This material has a deep as well as rich color, looks very good in daylight, as well as it doubles as a safety device at night.
• Measure correctly. For an average car, you will need two rolls for a single pinstripe. Four rolls for a double stripe.

Different tape brands have varying tensile strength. Generally non reflective tapes can be stretched for a straight line alongside of a vehicle. Reflective tapes or Pinstripe should not be stretched. Excessive stretching can cause cracking in the reflectors base and will damage the tape.