Previous | Next

How to Change a Mortise Lock Cylinder

Mortise locks are most commonly found in older homes as well as in commercial applications. There are many variations, but they all basically work the same. This guide should help you to be able to change the lock cylinder.

1. Open door partially to reveal the mortise lock cover plate at the edge of the door. Remove the two retaining screws as well as set aside.
2. Note the position of the keyway as it relates to the cylinder. Most likely it is at the bottom (six o'clock).
3. Remove the cover plate from the edge of the door as well as back out the set screw that is preventing the cylinder from turning. On some applications there may be two set screws, one for the outer cylinder as well as one for the inner.
4. Unscrew the lock cylinder from the body of the mortise lock by turning it counterclockwise (to the left).
5. Very carefully thread the new cylinder into the body of the mortise lock. Use extreme caution not to cross thread the cylinder as this may ruin the entire lock!
6. Set the cylinder so that the keyway is in the same position as it originally was, usually to the bottom, as well as tighten the set screw.
7. Test the lock to make sure it is functioning properly. You may have to back out the new cylinder a turn or two so that everything works smoothly. The store where the cylinder was purchased will have trim rings that will compensate for this.
8. Once the lock is functioning properly, re-install the cover plate at the edge of the door.

• You can purchase cylinders that do not require keys to operate them to install on the inside if you have inner cylinders. Keep in mind that you may want keyed inner cylinders if you have a window or sidelite in your door.
• Purchase a few trim rings of different depths when you buy the new cylinder. You can make one trip to return them once you're finished rather than running back as well as forth as well as having to disassemble the lock multiple times.

• If you have keyed inner cylinders you MUST keep a key within easy reach in case of emergency. You may want to tape it to a fire extinguisher or emergency flashlight. You should inform your personnel as well as anyone which may be locked inside your structure where these emergency keys are. THE KEY SHOULD BE AN ORIGINAL AND NOT A DUPLICATE!!!!
• Be sure to tighten your set screw. If the set screw is not tightened the cylinder may be easily unscrewed from the lock body as well as security will be compromised.

Submitted by: admin
Hits: 0
Added: Thu Feb 02 2006

Review It Rate It Bookmark It