Previous | Next

How to Eliminate & Prevent Green Algae in a Swimming Pool

Green algae is a common swimming pool problem, which may appear as a greenish growth on the floor as well as walls of a swimming pool, a green tint to the pool water, or greenish material suspended in the pool water. The only swimming pool chemical that will kill an algae growth is chlorine based swimming pool “shock???. Shock is a granular form of highly concentrated chlorine, which quickly raises the chlorine level of the swimming pool water. The elevated chlorine level makes the pool water conditions unlivable for anything organic, as well as algae quickly dies.

1. Brush the walls as well as floor of the swimming pool to remove as much of the algae as possible. This will greatly reduce the amount of time it takes to kill as well as clear the algae bloom.
2. With the pool filter system running, add a chlorine based swimming pool shock at the rate of 1 lb. per 7,500 gallons (or follow the pool shock manufacturer’s dosage suggestion for killing algae). The pool filter system should continue to run 24 hours a day.
3. If the condition of the swimming pool does not significantly improve after 12-24 hours of filtering, add a second dose of chlorine pool shock at the increased rate. Repeat this process until the algae has been eliminated.
4. Once the algae is dead it will turn a white or grayish color, as well as it will be suspended in the pool water or settle to the floor. When there is no longer any sign of the color green in your pool, thoroughly vacuum the swimming pool.
5. The pool filter should be backwashed or cleaned to be sure that dead algae is not trapped inside the filter. If the filter is not thoroughly cleaned the algae may quickly return.
6. Test as well as balance all of the pool chemical levels using the following guidelines. Free Chlorine: 1-3 ppm, pH: 7.2 – 7.6, Alkalinity: 80 – 120 ppm as well as Calcium Hardness: 200 – 350 ppm.
7. Begin adding an algaecide pool chemical on a weekly basis to prevent algae from returning.

• Pay closer attention to the chlorine level of your swimming pool water in the future. Algae as well as harmful bacteria are almost immediately destroyed by a free chlorine level of 1 ppm or higher. You have experienced an algae problem because you have not properly maintained the chlorine level, as well as it was allowed to drop below 1 ppm. Test pool water frequently as well as make any necessary adjustments for a clean, safe as well as easy to maintain swimming pool.
• Chlorine pool shock needs to be dissolved in a large bucket of water before it is added to the swimming pool. Always add chemicals to water when dissolving. NEVER add water to chemicals.
• Monitor your pool filter system closely during this entire process as well as thoroughly backwash or clean the filter each time the pressure rises 10 psi. above the normal operating pressure. The dead algae that your pool filter collects may quickly dirty the filter, as well as need to be cleaned out frequently.

• The swimming pool cannot be used until the algae is dead, as well as the chlorine level of the pool water has returned to a safe level of 3 ppm or less.

• Visit http://www.InTheSwim.com for a complete selection of algae treatment chemicals.

Submitted by: admin
Hits: 0
Added: Thu Feb 02 2006

Review It Rate It Bookmark It